Mitsubishi EVO X Repair Manual page 13

Removal steps (Continued)
5. Control wiring harness connection
6. Engine oil level gauge
7. O-ring
B
>> <<
8. Manifold absolute pressure sensor
B
>> << 9. O-ring
A A
<< >> >> << 10. No.2 Intake air temperature sensor
11. Gasket
12. Vacuum hose connection
13. Purge control solenoid valve
14. Starter wiring harness clamp
15. Intake manifold stay (front)
16. Starter wiring harness clamp
17. Intake manifold stay (rear)
18. Intake manifold
19. Intake manifold gasket
20. Harness bracket
21. Engine upper cover bracket (front)
Required Special Tool:
• MB992188: Fuel Injection Pipe Wrench
MB992188
No.2 Intake air temperature sensor
MB992188
No.2 Intake air temperature sensor
INTAKE AND EXHAUST
INTAKE MANIFOLD
REMOVAL SERVICE POINT
.
<<A>> NO.2 INTAKE AIR TEMPERATURE SEN-
SOR REMOVAL
Use special tool MB992188 to remove the No.2 intake air tem-
perature sensor.
AC707100 AC
INSTALLATION SERVICE POINTS
.
>>A<< NO.2 INTAKE AIR TEMPERATURE SEN-
SOR INSTALLATION
Tighten the No.2 intake air temperature sensor to the specified
torque by using special tool MB992188.
Tightening torque: 14 ± 1 N⋅ m (120 ± 13 in-lb)
AC707100 AC
.
TSB Revision
15-13