Before you start - what you should have: • KAntrak™ 1700 unit (1) • Locking ring (2) • KAntrak™ 1700 Brand Sticker (3) • Installation Manual (4) • GEM Application User's Guide (5)
Installation guide Thank you for choosing the KAntrak™ 1700 display. These pages provide a brief introduction to the KAntrak™ 1700 display but more importantly the recommended installation instructions. Please read through this guide before use. We hope you will be very happy with this KAntrak™ product and have many years of trouble-free operation.
1. The KAntrak™ Platform Kongsberg Automotive KAntrak™ 1700 LCD display is a rugged 75x75mm DIN-format module with 3 soft keys, and offers a 128 x 64 pixel display area. This is large enough to support monitoring and diagnostic data available on the latest generation of electronically controlled systems.
KAntrak™: Like a PC, a KAntrak™ needs application software to provide a useful function. One example of application software written by Kongsberg Automotive is the GEM (Generic Engine Monitoring) software written to display electronically controlled diesel engines and transmission performance parameters and faults/alarm using the SAE J1939 protocol.
Page 8
If you would like to obtain a quote for custom application software or would like to discuss the purchase of an SDK, please contact us at kantrak.info@ka-group.com More information is available via http://www.kongsbergautomotive.com/ page 5...
3. KAntrak™ Connection Data The KAntrak™ interfaces to data via the Deutsch DT04-6P connector on the rear of the display - wired as shown (see pinout diagram). The rear connector can be wired to the vehicle electric system using the Deutsch DT06-6S mating part. Connector pin out Signal Notes...
4. Typical J1939 Wiring Topology Most modern engine installations include a harness with built in J1939 backbone. (Check engine manufacturer's document- ation). If not, it is critical to use twisted shielded pair with a drain wire (max length 40m) terminated with 120 ohm resistors at each end.
5. KAntrak™ Installation Units are designed to be mounted onto a bulkhead, dashboard or panel. The method is described below. The only required component is the plastic locking ring (PF0709) supplied with every KAntrak™. Instructions: • Decide on a location •...
6. Maintenance and Troubleshooting No regular maintenance is required, except for cleaning the KAntrak™ lens as required using a soft, damp cloth. Do not use abrasive material or solvents, specifically white spirit, petrol and acetone. Should any further attention be necessary, please contact your supplier.
7. Glossary Controller Area Network (also referred to as CANbus); serial communication protocol for automotive use KAntrak™ Intelligent CAN-compatible LCD display module Generic Engine Monitor International Standard Organisation J1939 SAE engine data protocol using CAN 2.0B Liquid Crystal Display Soft keys Push-button keys whose function change according to use page 12...
8. Important Safety and Legal Information Under no circumstances shall Kongsberg Automotive or any of its subsidiary companies accept liability for any loss of data, income, incidental damage or consequential losses incurred as a result of the use of the product howsoever caused when used as a monitor for electronically-controlled engines /transmissions or other systems.
Page 17
• If the LCD fluid gets onto your skin wipe immediately with a suitable cloth and wash the area well with mild soap and water. • If the LCD fluid gets into your eyes thoroughly rinse your eyes with clean water for several minutes and then immediately seek medical assistance.
Page 18
Buffer Page Cardboard covers must be printed on face side only...