Advertisement
Quick Links
Series 2200 Room Units
Product Description
These room units measure temperature in the
occupied space in which they are installed. Models
with display allow users to view the measured
temperature value. A version with temperature
setpoint adjustment is also offered.
The effective sensing and setpoint range is 55°F to
95°F (13°C to 35°C).
These room units can be mounted on electrical
boxes, stud-type mounting brackets, or drywall.
Hardware is included for installation on drywall or on
a 2" × 4" electrical box.
Product Numbers
QAA2212.xWxN
QAA2220.xWxN
QAA2221.xWxN
QAA2230.EWxN
Accessories
AQA2200-INTL
Room Unit Back Plate (10-pack)
563-102 GSKT KIT Room Sensor Insulating
Gasket (10-pack)
(For hollow wall installations)
Caution Notations
CAUTION
Expected Installation Time
20 minutes
Item Number 129-477, Rev. JA
QAA2232.xWxN
QAA2235.xWxN
QAA22SS.xWxN
Equipment damage or loss of
data may occur if you do not
follow a procedure as
specified.
Installation Instructions
Required Tools
·
Sizes 1 and 2 Phillips screwdrivers
·
Small and medium flat-blade screwdrivers
·
1/16-inch hex key
·
Medium-duty electric drill
·
3/16-inch (4.8 mm) drill bit
·
One-inch (25 mm) hole saw
·
Small level
·
Tape measure
·
Marker or pencil
Prerequisites
·
Review these instructions before beginning.
·
Installed: appropriate field wiring within the
maximum wiring run length for the individual
equipment controller. The maximum
recommended length is 100 feet (30 m).
·
All wiring must comply with National Electric
Code (NEC) and local regulations.
Figure 1. Typical Temperature Room Unit.
Document No. 129-477
November 15, 2017
Page 1 of 4
Advertisement
Related Manuals for Siemens QAA2212.*W*N
Summary of Contents for Siemens QAA2212.*W*N
-
Page 1: Product Description
Installation Instructions Document No. 129-477 November 15, 2017 Series 2200 Room Units Required Tools Product Description · Sizes 1 and 2 Phillips screwdrivers These room units measure temperature in the · Small and medium flat-blade screwdrivers occupied space in which they are installed. Models ·... - Page 2 Base. The Sensor Base has an UP arrow molded into the surface in the same quadrant location (see Figure 6). NOTE:See Figure 2 for details on optional Gasket application. Figure 3. Drywall Mounting (No Rough-in), Typical. Page 2 of 4 Siemens Industry, Inc.
- Page 3 Tighten the two mounting screws to the room unit base plate. CAUTION: Over-tightening may cause the room unit base plate to crack or bend. 4. Continue with Drywall Mounting (No Rough-in), Typical, Steps 6 through 8, and Sensor Set-up. Siemens Industry, Inc. Page 3 of 4...
- Page 4 Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as design improvements are introduced. APOGEE is a registered trademark or Siemens Industry, Inc. Other product or company names mentioned herein may be the trademarks of their respective owners.