Installation Instructions; Step 1 - Unpack Dehumidifier; Step 2 - Install Direct Drain - Haier HEN70ETFP Installation And User Manual

POWER SUPPLY CORD
Wiring Requirements
•
115 Volt, 60Hz, 15-amp fused grounded 3 prong outlet
•
The use of a time-delay fuse or time-delay circuit breaker
is recommended.
•
Use a dedicated circuit only.
NOTE: Do not operate any other electrical
appliances on this circuit or you may trip the circuit
breaker/fuse.
REQUIRED GROUNDING METHOD
This dehumidifier must be grounded. The dehumidifier is
equipped with a power supply cord that has a 3 prong
grounding plug. The power supply cord must be plugged into
a mating, grounded 3 prong outlet, and grounded in
accordance with all local codes and ordinances.

INSTALLATION INSTRUCTIONS

STEP 1 - UNPACK DEHUMIDIFIER

WARNING
Excessive Weight Hazard
Use two or more people to move and install
dehumidifier.
Failure to do so can result in back or other injury.
•
Remove packaging materials. Save the carton and the
foam packaging for storing the dehumidifier when not in
use.
NOTE: There are no packing materials inside the
dehumidifier to remove. Do Not open the cabinet.
•
Properly dispose of/recycle all packing material.
•
Handle the dehumidifier gently.
•
Keep the dehumidifier upright and level. Do not set the
dehumidifier on its side, front, back or upside down.

STEP 2 - INSTALL DIRECT DRAIN

(Optional)
If you plan to operate your dehumidifier continuously, and
you are placing it near a floor drain, such as in a basement,
you may decide to install a direct drain to avoid having to
empty the water collection bucket.
1. Unscrew and remove the drain cover on the back of the
dehumidifier.
2. Remove the soft, rubber stopper. Place the drain cover
and stopper into the water bucket for safe keeping.
3. Connect a drain hose (not provided) to the garden-hose
style drain connection.
4. Lower the drain hose horizontally into a drain.
4
115V
15 Amp
A Rubber
Stopper
a
B Drain Cover
b
A Drain Hose
a