Table of Contents
Advertisement
InfraRed Thermometer User Manual
11.Data Logger
11-1.Storing Data
Your thermometer is capable of storing up to 20 data locations.
The infrared temperature and temperature scale ( C or F) are also
°
°
stored.
11-2.Infrared
To store data from an infrared reading, pull the trigger. While holding
the trigger, press the
"
MODE
"
button until LOG appears in the lower
left corner of the display; a log location number will be shown. If no
temperature has been recorded in the shown LOG location, 4 dashes
will appear in the lower right corner. Aim the unit at the target area
you want to record, and press the laser/backlight button. The recorded
temperature will appear in the lower right corner. To select another
log location, press the up and down keys.
11-3.Recalling Data
To recall stored data after the unit shuts off, press the "
MODE
" button
until LOG appears in the lower left corner. A LOG location number will
be shown below LOG, and the stored temperature for that location
will be display. To move to another LOG location, press the UP and
Down keys.
11-4.Log Clear Function
The Log clear function allows you to quickly clear all logged data
"
"
points. This function can only be used when the unit is in LOG mode.
It can be used when the user has any number of LOG locations stored.
You should only use the LOG clear function if you want to clear all the
Log location data that is stored in unit's memory. The "LOG clear"
function works as follows:
•While in LOG mode, press the trigger, and then press the "down"
arrow button until you reach LOG location "0".
Note:
This can only be done when the trigger is pulled. LOG location
"0"cannot be accessed, by using the "up" arrow button.
11
Hide quick links:
Advertisement
Table of Contents
