Whirlpool HB10813 Operation Manuals page 10

Installation of the Remote Control
1. Take out the remote control from the holder.
2. Install the remote control to suitable place. Check the main body can receive signal from
the remote control installation location or take out the remote control to check the
receiver sensitivity. The installation location cannot be toward the direct spraying area
of the shower.
3. Fix the remote control holder to the designed place and make marks according to the
arrows.
4. Dig holes according to the mark, fill the holes with 2 plastic plugs, and fix the holder with
screws.
5. Install two R03 (AAA) batteries to the remote control:
A) Rotate the knob
B) Open the battery cover
C) Install two R03 (AAA) batteries to the remote control
(pay attention to the directions of positive and negative electrode)
D) Replace the battery cover
E) Rotate the knob
6. Place the remote control back to the holder.
clockwise to the position
anti-clockwise to the position
- 9 -