Advertisement
SET UP
• Turn the Inflator "ON" by depressing and
releasing the "ON/UNIT" button (Fig A).
The Digital Display will read 0.0
• Select the desired units of pressure
measurement by depressing and holding in the
"ON/UNIT" button for 3 seconds, until the units
change. (The "Units" indicator will appear to
the right of the 0.0). Repeat the procedure until
the desired units are achieved (psi, bar, kpa or
kg/cm2). Release the button.
• Depress "LIGHT" button to illuminate display
backlight. Depress again to turn light off.
• Depress the "OFF" button to turn Inflator off.
OPERATION
• Connect air supply to the Inflator (Fig B).
• Depress the Thumb Lever and attach the Fill
Fitting to the valve stem. Release Thumb Lever
to allow clamp to latch onto valve stem (Fig C).
• Depress the Fill Lever fully to release air
into tire.
• Release Fill Lever fully and read pressure in
Digital Display.
• If pressure goes higher than desired, depress
the Fill Lever half-way to bleed off pressure
until proper pressure is achieved.
• Depress the Thumb Lever once again to
release clamp and pull Fill Fitting from
valve stem.
BATTERY REPLACEMENT
• Remove Battery Cover at left rear of gauge
housing by pushing in and release plastic latch.
• Remove Batteries.
• Replace Batteries with (2) CR2032.
NOTE: + side is placed facing upward and
under contacts (Fig D).
To order parts and supplies: 800.345.1178 >> eastwood.com
FIG. A
FIG. A
FIG. B
FIG. B
FIG. C
FIG. C
FIG. D
FIG. D
3
Advertisement
