Installing The System - BONSAI VELOCITY OM-812 Product Information And Instructions

ASSEMBLY AND USE

INSTALLING THE SYSTEM:

STEP 1: Loosen the cylinder adjustment knob.
STEP 2: Lower the BONSAI
STEP 3: Line-up the two pins and the seal washer
STEP 4: While holding the unit in place, tighten
STEP 5: Attach a standard cannula (7 ft� (2�13 m) or less in length) to the oxygen
9
VELOCITY conserver
®
over any post-valve cylinder with the
alignment pins toward the holes on the
cylinder neck [see Fig. F].
(gasket) with the corresponding holes on
the cylinder post valve�
*
NOTE: The cylinder adjustment knob should
be aligned with the indentation on the post valve.
the cylinder adjustment knob by turning
clockwise [see Fig. F].
*
NOTE: Tighten only by hand. The use of a tool to tighten the knob may damage the unit.
supply outlet�
FIGURE F
Attaching the BONSAI ® VELOCITY
Conserver to the Cylinder