Diagnostic Software, Trouble Shooting and Test Instructions
5.3.15 No VFD Display
No VFD display but the control keys on front can
be operated normally
Go
Check point : pin 1, 2 (AC1) and pin 31, 31 (AC2)of
VFD on front panel
Observe : check the AC1 to ground is -15.6v AC
and AC2 to ground is - 18v3 AC
No
Check point : R228 on power board
Observe : check the resistor is opened
No
Check point : R217 on power supply board
Observe : check the resistor is defected
No
Solution : Check the diodes D204 and C205, replace
the component if defected
Solution : replace the VFD
Yes
display
Solution : replace the resistor
Yes
R228
Solution : Replace the defected
Yes
resistor
Figure 5-15
DVD580M
5.
CL 26532085-072.eps
EN 27
180702