Advertisement
ADVANCED OPERATIONS :
1、The motor can switch directions depending on the alignment of
the lens.
2、LCD INFO:
1st LINE: FREQUENCY= 2. 4GHZ CHANNEL= Current Channel
2nd LINE: Signal Level= Signal connection. If no response, need to
restart receiver. 3rd LINE: TX= Remote battery level. Normal range =
3.4-4.2V.
3、The First time you turn on the motor it appears still so you need
to do the automatic scan.
Hold the NERVE button for 3 seconds until the motor starts turning,
The automatic scan will begin. After it finishes the motor gear will
stop in the middle point of the range. Then turn the dial full range in
both directions. Repeat this step for dual and triple channel
versions.
4、After calibration, the marking disc can be used with correct
distance information. Use tape and a marker on the disc.
5、To do the manual A-B hard stops, whilst turning the dial press
once to set start and hold to set end. To cancel, press twice.
6、If the same lens is used after powering off, press NERVE button
once.
Advertisement
