Advertisement
43-3201.fm Page 2 Thursday, January 20, 2000 7:09 AM
FCC STATEMENT
Your telephone complies with Part 68 of
FCC Rules . You must, upon request,
provide the FCC registration number
and the REN to your telephone compa-
ny. These numbers are on the bottom of
your phone.
Note: You must not connect your tele-
phone to:
• coin-operated systems
• party-line systems
• most electronic key phone systems
SETUP
Plug the handset cord into the jacks on
the handset and on the base's side.
If you want to place the phone on a
desk, plug one end of the supplied long
telephone cord into the jack on the bot-
tom of the base. Press the cord into the
channel provided to keep it out of the
way. Plug the cord's other end into a
modular phone jack.
If you prefer a wall phone to a desk
phone, you can mount the phone on a
wall plate or directly on a wall.
Wall Mount with Wall Plate
1. To mount the phone on a wall plate,
plug one end of the supplied short
telephone cord into the jack on the
bottom of the base.
2
2. Plug the cord's other end into the
modular jack in the wall plate.
3. Fit the wall-plate studs into the key-
hole slots on the bottom of the
phone's base, then slide the phone
down until it is secure.
4. Before you hang up the phone's
handset, slide up the handset holder
to remove it, turn it over so its
tabbed edge faces up, then slide it
back down into its slot.
Wall Mount without Wall Plate
1. To mount the phone directly on a
wall, drill two holes 3
apart as shown, then thread a screw
(not supplied) through each hole,
letting the head extend about
inch from the wall.
Note: Be sure to use screws with
heads that fit into the keyhole slots
on the bottom of the phone.
15
/
inches
16
1
/
8
Advertisement
