Advertisement
2. Attaching the ZR-2000 to a tripod
1. Unscrew and remove the tripod fitting.
2. Affix to the tripod fitting the included non-slip rubber layer.
• This will prevent the ZR-2000 sliding on the panning handle.
3. Position the tripod fitting on the panning handle and secure it in place.
3.Attaching the optional Color Viewfinder Unit FU-2000
You can attach to the ZR-2000 the optional Color Viewfinder Unit FU-2000.
1. Remove the protection cover from the FU-2000.
2. Fit the FU-2000 into the attachment section of the remote controller.
3. Tuck the remote controller's cable into the groove on the bottom part of the FU-
2000 and turn the stopper to fix the cable in place.
• Do not attempt to disassemble or modify this unit.
• Do not subject this unit to strong vibrations or shocks.
• Do not leave the unit in direct sunlight, near heat radiating objects, inside
a hot car, or in other hot places, as this may deform or discolor the unit.
• Do not insert the plug into any jack or terminal other than the LANC
terminal of the camcorder.
• Keep the connection plug clean at all times.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-
Consult the dealer or an experienced radio I TV technician for help.
Do not make any changes or modifications to the equipment unless otherwise specified
in the manual. If such changes or modifications should be made, you could be required
to stop operation of the equipment.
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus as set out in the interference-causing equipment standard entitled
"Digital Apparatus. ICES-003 of the industry Canada."
Specifications
Plug:
<P
2.5 mm stereo miniplug (LANC
4!
Standard)
LANC cable length:
3.3 m (1 0.8 ft.)
Operating temperature range: 0°-40°C (32°-1 04 °F)
Dimensions (D
x
W
x
H):
110
x
58
x
40 mm (4.3
x
2.3
x
1.6 in.)
Weight:
153 g (5.4 oz.)
Weight and dimensions are approximate and subject to change without notice.
Errors and omissions excepted.
Advertisement
