Work Area Safety; Electrical Safety; Personal Safety - Bosch GRL 500 H Operating/Safety Instructions Manual

FCC Statement
This product has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices,
a separation distance of 8-in (20 cm) or more should be maintained between antenna of this
device and persons during operation. To ensure compliance, operation at closer than this
distance is not recommended.
The antenna(s) used for this transmitter must not be co-located or operating in conjuction with
any other antenna or transmitter.
This device complies with Industry Canada license exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Declaration of Conformity
We declare under our sole responsibility that the product described under "Technical Data"
is in conformity with the following standards or standardization documents: EN 61010-1,
EN 60825-1 (measurement tool) according to the provisions of the directives 2006/95/EC,
2004/108/EC, 2006/42/EC.
Work area safety
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
DO NOT operate the laser tool around
children or allow children to operate the
laser tool. Serious eye injury could result.
DO NOT use measuring tools,
attachments and accessories outdoors
when lightening conditions are present.
DO NOT operate the
! WARNING
measuring tool in explosive
atmospheres, such as in the presence of
flammable liquids, gases, or dust.
Electrical safety
Batteries can explode or leak, cause
injury or fire. To reduce this risk, always
follow all instructions and warnings on the
battery label and package.
In case of damage and improper use of
the battery pack, vapors may be emitted.
2610A16816.indd 11
Provide for fresh air and seek medical
help in case of complaints. The vapors can
irritate the respiratory system.
Personal safety
Stay alert, watch what you are doing and use
common sense when operating a tool. Do
not use a tool while you are tired or under
the influence of drugs, alcohol or medication.
A moment of inattention while operating a
tool may result in serious personal injury or
incorrect measurement results.
Use safety equipment. Always wear eye
protection. Safety equipment such as dust
mask, non-skid safety shoes, hard hat, or
hearing protection used for appropriate
conditions will reduce personal injuries.
DO NOT use the laser viewing glasses as
safety goggles. The laser viewing glasses are
used for improved visualization of the laser beam,
but they do not protect against laser radiation.
-11-
12/8/15 2:53 PM