Connecting To An Audio Source; Mode Switch - Radio Shack Speaker User Manual

Connecting to an Audio Source

You can connect the transmitter to your
audio source's left and right audio output
jacks or its headphone jack.
Cautions:
• Do not connect the transmitter to your
audio source's speaker output. Doing so
could damage the transmitter and the
audio source.
• If you connected the transmitter to an
audio source's headphone jack, set the
audio source's volume control to its
middle-position.
1. Connect one end of the supplied audio
patch cord to the transmitter's audio
jacks (white plug to
red plug to
R AUDIO IN
2. If you are using the audio source's output
jacks, connect the white and red plugs
at the other end of the patch cord
directly to the audio source's
corresponding left (white) and right
(red) audio jacks.
If you are using your audio source's stereo
headphone jack, connect the patch cord's
white and red plugs to the white and
red phono jacks on the phono side of
1
the / -inch supplied adapter.
8
If your audio source has a
headphone jack, insert the adapter's
inch stereo plug into the audio source's
HEADPHONE jack.

Mode Switch

For normal stereo use, set
on the back of the transmitter, to
If you are using a monaural system, set
STEREO/MONO
and
L AUDIO IN
).
1 / -inch
8
1 / -
8
STEREO/MONO,
STEREO
to .
MONO
.
3