Seat MEDIA SYSTEM PLUS Owner's Manual page 25

If you do not remove the CD in the following
10 seconds, it will be drawn back in for safety
reasons, without changing to CD mode.
Unreadable or defective CD
If the data on the inserted CD cannot be read
or the CD is damaged, the corresponding in-
dication will be shown on the screen.
Depending on the unit, when a CD cannot be
read it will retry three times, ejecting and re-
inserting the CD, before showing the indica-
tion.
Note
Uneven road surfaces and strong vibrations
●
may cause the CD to jump.
● If the interior temperature of the unit is too
high, it will not accept or play any more CDs.
● If, after having inserted several CDs, the in-
dication still appears, contact a
CD drive error
specialist workshop.
Inserting and removing memory cards
Inserting a memory card
If a memory card cannot be inserted, make
sure it is positioned correctly and is compati-
ble with the unit.
Playback starts automatically if supported
audio files are stored on the memory card.
Audio mode
Insert a compatible memory card by pushing
it into the memory card slot with the cut-off
corner first facing upwards until it locks in
›››
Fig. 20.
Removing a memory card
The memory card inserted must be prepared
before it is ejected.
Press the infotainment button
●
press to open the menu System set-
Setup
.
tings
● Press the function button
or
Remove SD card 1 safely Remove SD card 2 safely
After ejecting the memory card, the function
button will be shown in grey.
● Press the memory card inserted. The mem-
ory card "jumps" to the eject position.
● Remove the memory card.
Unreadable memory card
If you insert a memory card containing data
that cannot be read, the unit will not change
to memory card mode after loading.
It will show the indication: There are no playa-
ble files available .
External audio source connected to
the AUX-IN multimedia socket
; then,
MENU
.
Standard representation: main menu
Fig. 21
MEDIA.
Depending on the market and the features,
the vehicle may have a MEDIA-IN multimedia
›››
Booklet Instruction
interface
must use an adaptor cable with a 3.5 mm
jack to connect the external audio source.
An audio source connected through AUX can-
not be operated using the infotainment sys-
tem. Playback is started, managed and stop-
ped using the external audio source.
Connecting an external audio source to the
AUX IN multimedia socket
● Reduce the base volume of the infotain-
ment system.
Connect the external audio source by con-
●
necting the AUX-IN multimedia jack.
manual. You
»
23