Table of Contents
Advertisement
5-4-25 Belt Pulley Removal
1) Remove the Belt Pulley Œ.
Note : Take extreme care not to get grease on Belt
Pulley Πat assembling or reassembling.
ΠBELT PULLEY
Fig. 5-38 Belt Pulley Removal
5-4-26 Damper Capstan Removal
1) Lift the Hook in the direction of arrow use the Flat
Tip. (Refer to Fig. 5-39)
2) Rotate the Damper Capstan in the direction of
allow
Note : Damper Capstan use the Sankyo Capstan
Motor (FQVB65) Only.
Fig. 5-39 Damper Capstan Removal
Samsung Electronics
5-4-27 Motor Capstan Ass'y Removal
1) Remove the 3 Screws Œ.
2) Remove the Motor Capstan Ass'y ´.
Assembly :
1) Match the 3 holes of Motor Capstan Ass'y ´ to the
3 holes of Main Base. Be careful not to drop or
knock the Motor Capstan Ass'y ´.
2) Tighten the 3 Screws Πin the direction of arrow
as shown detail drawing.
Note : After tightening screws, check if there is gap
between the head of screws and the top side of Main
Base. There should have no gap between the head of
screws and the top side of Main Base.
After reinstalling, adjusting the tape transport
system again.
Π3 SCREWS
Fig. 5-40 Motor Capstan Ass'y Removal
Disassembly and Reassembly
C
A
B
´ MOTOR CAPSTAN ASS'Y
5-19
Hide quick links:
Advertisement
Table of Contents
