(Stimulation, Contrac tion and Relaxation.) Powered mus cle stimulators should only be used under medical supervision for The Premier EMS is a fully digital battery operated pulse generator adjunctive therapy for the treatment of medical diseases and that sends electrical impulses to the nerves and underlying muscle conditions.
10.Portable powered muscle stimulators should not be used while Chapter 7 : CONSTRUCTION driving, operating machinery, or during any activity in which involuntary muscle contractions may put the user at undue risk of injury. Chapter 4 : WARNINGS 1. The long-term effects of chronic electrical stimulation are unknown.
Chapter 8 : TECHNICAL SPECIFICATIONS BACK SIDE The technical specification details of Premier EMS are as follows: MECHANISM TECHNICAL DESCRIPTION 01 Channel Dual, isolated between channels 02 Pulse Amplitude Adjustable, 0-100 mA peak into 500 ohm load each channel. 03 W ave Form...
The stimulation of the CH2 will occur after Mode(A) the 1st contraction of CH1 is completed. In The replaceable parts and accessories of Premier EMS devices this mode, the setting of ON Time should are as given below - be no less than two times of the "Ramp"...
their corresponding terminals in the device. Make sure that the II. LABEL unit is turned off. T he label attached to the bac k of devic e 2) Insert the lead wires into the lead wire sockets on top of the contains important information about this device.
After connecting the wires to the stimulator, attach each wire to the initial results are not positive, speak to your physician about an electrode. Use care when you plug and unplug the wires. alternative stimulation settings and/or electrode placements. Once Jerking the wire instead of holding the insulated connector body an acceptable placement has been achieved, mark the electrode may cause wire breakage.
Important Chapter 18: APPLICATION OF RE-USABLE SELF ADHESIVEELECTRODES 1. Do not apply to broken skin. 2. The electrodes should be discarded and re-ordered from your physician when they are no longer adhering. Application 3. The electrodes are intended for single patient use only. 1.
Page 10
The intensity level can be increased by pressing this button. There are 99 steps of intensity adjustment control. Press the button until the desired intensity level is reached. 8. Intensity Decrease Control The intensity level can be decreased by pressing this button.
Page 11
In Alternate mode, the OFF Time should be equal or more than the ON Time. (OFF TIME ≥ ON TIME) c. Set Ramp Time The ramp time controls the time taken to reach maximum and the time taken to fall to zero I order to make the contraction f .
13. Check/Replace the Battery: stimulation is started. Output will be terminated when time is Over time, in order to ensure the functional safety of up. Turn off the unit when the output is off. EMS, changing the battery is necessary. Continuous End of Treatment 1.
For safety reasons, review the following checklist before using (c ) Do not short the terminals of the battery. This will cause the your Premier EMS. battery to get hot and can cause permanent damage. Avoid 1.Check the device for external damage.
Chapter 25 : WARRANTY Should any malfunctions occur while using the Premier EMS , check All Premier EMS models carry a warranty of one year from the date of delivery. The warranty applies to the stimulator only and - whether the parameters are set to the appropriate form of therapy.
Need help?
Do you have a question about the Premier EMS and is the answer not in the manual?
Questions and answers