Elo TouchSystems 3202L User Manual page 8

Connector Panel & Interfaces
Touchmonitor & Computer Module Connections
1. Once the Computer Module has been installed, connect the AC power cable between the touchmonitor's POWER IN connector and the AC power
source.
a. NOTE: Computer Module can be installed when the AC power cable is connected (Hot pluggable). Do not remove the Computer Module
unless it is completely shut off.
2. Make any desired connections to the Computer Module connector panel.
3. Press the touchmonitor's power button to turn on the Computer Module.
Operating System Setup – Windows® 7
The initial setup of the operating system takes approximately five minutes. Additional time might be needed for different hardware and operating system
configurations. You will need to plug in an external mouse and/or keyboard into the Computer Module connector panel to execute these steps.
To set up the Windows 7 OS for the Computer Module, turn on the touchcomputer and follow the instructions on the screen.
User Manual – IDS Computer Module UM600229 Rev. A, page 8 of 37