Conrad 98 91 96 Operating Instructions Manual page 52

• You can change the IP address of the access point in the fi rst confi guration window. It would
be sensible, e.g., when you assign it an IP address in the range of your router to later access
the access point again easily without effort. If your router has, e.g., the address 192.168.178.1,
you will assign the AP, e.g., the address 192.168.178.250. You only need to observe that the
fi rst three blocks remain the same and the last block is not yet present in your network. Best
leave the "Subnet Mask" unchanged.
Now click "Next".
• The WLAN is confi gured on this page. If desired, change the WLAN name fi rst. For this, enter
any name of letters and fi gures behind "Network Name (SSID)". Underscore and dashes are
also permitted.
To activate encryption, open the menu behind "Security Mode" and best select "WPA2-PSK".
Enter the safest password possible in the fi eld "Pre-Shared Key". The same characters as in
the name are permitted here. The password must consist of at least 8 characters.
Click the button "Apply" to save and complete setup.
52