Chevrolet TRAX 2018 Owner's Manual page 32

: Press to unlock the driver door.
Press again within five seconds to
unlock all doors.The RKE
transmitter can be programmed to
unlock all doors on the first button
press. See Vehicle Personalization
0 132.
The hazard warning lamps may
flash to indicate unlocking. See
Vehicle Personalization 0 132.
Pressing will disarm the alarm
system. See Vehicle Alarm System
0 44. If equipped, pressing
also unlock the fuel door.
: If equipped, press and hold
briefly to initiate vehicle locator. The
exterior lamps flash and the horn
chirps three times.
Press and hold for at least
three seconds to sound the panic
alarm. The horn sounds and the
turn signals flash for 30 seconds,
or until is pressed again or the
key is placed in the ignition and
turned on or to ACC/ACCESSORY.
: If equipped, press
press and hold
engine from outside the vehicle
using the RKE transmitter. See
Remote Vehicle Start 0 38.
The RKE transmitter buttons will not
operate when the key is in the
ignition.
Programming Keys to the
Vehicle
Only RKE keys programmed to this
vehicle will work. If a key is lost or
will
stolen, a replacement can be
purchased and programmed through
your dealer. When the replacement
key is programmed to this vehicle,
all remaining keys must also be
reprogrammed. Any lost or stolen
keys will no longer work once the
new key is programmed.
Programming with Two
Recognized Keys
To program a new key:
1. Insert the original, already
programmed key in the ignition
and turn the ignition on.
Keys, Doors, and Windows
2. Turn the ignition off and
and then
to start the
3. Quickly, within five seconds,
4. Turn the ignition off, and
5. Insert the new key to be
6. Repeat Steps 1 5 if additional
If a key is lost or damaged, see your
dealer to have a new key made.
Programming without Two
Recognized Keys
Program a new key to the vehicle
when a recognized key is not
available. Canadian regulations
require that owners see their dealer.
If two currently recognized keys are
not available, follow this procedure
to program the first key.
remove the key.
insert the second original
already programmed key in the
ignition and turn the ignition on.
remove the key.
programmed and turn the
ignition on within five seconds.
The security light will turn off
once the key has been
programmed.
keys are to be programmed.
31