Chevrolet TRAX 2018 Owner's Manual page 192

of the cord will prevent engine
heater operation at temperatures
above 18 °C (0 °F).
Warning
Do not plug in the engine block
heater while the vehicle is parked
in a garage or under a carport.
Property damage or personal
injury may result. Always park the
vehicle in a clear open area away
from buildings or structures.
To Use the Engine Heater
1. Turn off the engine.
2. Open the hood and unwrap the
electrical cord. The cord is
located in the driver side of the
engine compartment, near the
battery. It is shipped from the
factory with a tie holding it in
place. Use care in removing
the tie so that the cord is not
damaged.
Check the heater cord for
damage. If it is damaged, do
not use it. See your dealer for
a replacement. Inspect the
cord for damage yearly.
3. Plug it into a normal, grounded
110-volt AC outlet.
Warning
Improper use of the heater cord
or an extension cord can damage
the cord and may result in
overheating and fire.
Plug the cord into a
three-prong electrical utility
receptacle that is protected
by a ground fault detection
(Continued)
Driving and Operating
Warning (Continued)
function. An ungrounded
outlet could cause an
electric shock.
Use a weatherproof,
heavy-duty, 15 amp-rated
extension cord if needed.
Failure to use the
recommended extension
cord in good operating
condition, or using a
damaged heater or
extension cord, could make
it overheat and cause a fire,
property damage, electric
shock, and injury.
Do not operate the vehicle
with the heater cord
permanently attached to the
191
(Continued)