Management Console System Configurations - Novra A75 Instructions Manual

Novra A75 Receiver

4.0 MANAGEMENT CONSOLE SYSTEM CONFIGURATIONS

4.1 Configuring the A75 Data Receiver
The data receiver configuration is very straightforward and can be shown in four basic steps:
1. Open (run) the A75 Management Console application
2. Configure the receiver IP addresses.
3. Set the receive channel.
4. Set the PID.
Each of these three basic steps is presented below.
Step 2: In figure 2, the A75 receiver IP addresses are configured according to the LAN at the receive site.
Figure 2: Receiver IP Addresses
Step 3: In figure 3, the receiver is tuned to channel 14, to match the broadcast modulator.
Confidential and Proprietary 7 of 11
Version DRAFT 2004APR29