Toro H132 Setup Instructions page 3

Assembling the Grass Collector
1. Slide the bag onto the frame and secure it with the clips
(Fig. 5).
Figure 5
1. Bag
2. Secure the handle to the bag assembly with 4 washers
(M9) and 2 locknuts (M8) (Fig. 6).
2
Figure 6
1. Bag assembly
2. Handle
Installing the Grass Collector
1. Reach beneath the rear of the tractor and hold the full
bag switch and switch plate while removing the 2
screws on the rear panel (Fig. 7).
1
2
2. Frame
1
4
3
3. Washer (M9)
4. Locknut (M8)
4
5
Figure 7
1. Rear panel
2. Switch
3. Switch plate
2. Hold the switch plate against the switch and slide the full
bag lever into the rectangular slot on the rear panel.
3. Hook the switch plate onto the lever and secure the
switch and switch plate to the rear panel with the 2
screws (Fig. 7).
4. Attach the grass collector to the rear of the tractor with
2 Z-brackets, bolts (M6 x 16.2 mm), and nuts (M6)
(Fig. 8).
Figure 8
1. Grass collector
2. Z-bracket
5. Attach the grass collector cover to the tractor with
2 pins (Fig. 9).
1
2
2
Figure 9
1. Grass collector cover
3
3
2
1
m-6101
4. Full bag lever
5. Screw
1
3
4
2
3. Bolt (M6 x 16.2 mm)
4. Nut ( M6)
2. Pin