Section 4: Adjusting The Angle Of The Stand For Different Roof Pitches; Section 5: Assembling The Collector And Geyser To The Stand - Satchwell HOTFLO Instruction

Section 4: Adjusting the angle of the stand for different roof pitches:

NB: Check that the geyser tank is horizontal when fixing stand to roof. To prevent an airlock, it is advised that the
cistern tank side of the geyser is slightly raised (5- 15mm).
Roof assemblies:
Figure 1:
Assembly for 5° Flat Roof

Section 5: Assembling the Collector and Geyser to the stand:

Place collector into assembled stand according to Collector Manufacturers specifications.
Place Geyser on top of the cradle as indicated ensuring that the geyser is centre to the collector
and that the cistern tank is perpendicular to horizontal. Using M6 x 16mm bolt, nut and washer
supplied secure Part L – Galvanized Hoop Iron x1000mm as indicated above to the main frame.
Using Part M – M6 x 80mm Hook bolt as supplied secure Geyser to stand as indicated above.
Angle of the stand can be changedby adjusting the arm (indicated left):
Figure 1: below: a 5° (Flat) Roof
Figure 2: below: a 17.5° Roof
Figure 2: below: a 30° and more Roof (no rear legs)
Figure 2:
Assembly for 17.5° Pitched Roof Assembly for 30° plus pitched roof
Figure 3:
Part D, secure Collector to Main Frame
Using
as indicated left. (NB Tighten M6 nut)
Repeat the process for the other side of the
Main Frame.
8