Section 3: Assembly - Rear Support Leg - Satchwell HOTFLO Instruction

Section 3: Assembly – Rear Support leg:
Step 6:
Start by laying out the components F to K
Support leg on a flat surface as indicated above.
Step 8:
NB: The bolts, nuts and washers on this assembly can be fastened properly and in the correct manner.
Step 10:
NB: Tighten all bolts and nuts on the Main Frame properly and in the correct
Step 7:
of the rear
Step 9:
Assemble F and I onto G
using the M6 x 16mm
bolts, nuts and washers
supplied.
Only finger tighten the
bolts, nuts and washers.
Using
16mm bolts, nuts and washers
supplied assemble the Main
Frame and Rear Support Leg as
indicated left. Only finger
tighten the bolts, nuts and
washers.
Then insert Collector to square
Main Frame (indicate right)
Assemble load spreading
horizontal legs (H onto G x2)
mirror assembly - using the M6 x
16mm bolts, nuts and washers -
bolt outside, washer and nut
inside. Only finger tighten the
bolts, nuts and washers.
Assembled parts F to J with Rear
Support Braces in place – bolts
outside, washers and nuts
inside.
2x Part K and the M6 x
manner.
7