Creating A User Tone - Radio Shack 735A-E-002A Owner's Manual

Synthesizer Mode
WK-3000
MODULATION button lamp

Creating a User Tone

Use the following procedure to select a preset tone and change
its parameters to create a user tone.
1
First, select the preset tone you want to use as a
basis for your user tone.
2
Press the SYNTH button.
• This enters the Synth Mode, which is indicated by the
pointer next to SYNTH on the display screen.
Parameter setting value
Currently selected parameter
A t k T i me
3
Use [ ] and [ ] CURSOR to display the parameter
whose setting you want to change.
V i b D e l a
• Each press of [ ] or [ ] CURSOR changes to the next
parameter. See "Parameters and Their Settings" on
this page for information on setting range for each
parameter.
4
Use [+] and [–] to change the setting of the currently
selected parameter.
• You can also use the number buttons to input a value
to change a parameter setting. See "Parameters and
Their Settings" on this page for information on setting
range for each parameter.
5
After you are finished editing the sound, press the
SYNTH button to exit the Synthesizer Mode.
E-54
SYNTH
NOTE
The following describes the function of each parameter and
provides its setting range.
Time it takes before the tone sounds after a key is pressed
Time the tone continues to sound after a key is released
y
High-band cutoff for the harmonic components of the tone
Resonance of the tone
• See "Storing a User Tone In Memory" on page E-57 for
details on saving user tone data to memory so it is not
deleted.
Parameters and Their Settings
Attack Time (Range: –64 to 00 to +63)
A t k T i me
Release Time (Range: –64 to 00 to +63)
R e l . T i me
Cutoff Frequency
(Range: –64 to 00 to +63)
C - o f f F r
Resonance (Range: –64 to 00 to +63)
R e s o n a n
CURSOR
[+] / [–]
q
.
735A-E-056A