Table of Contents
Advertisement
GYRO CALIBRATION
If the drone is experiencing difficulty flying or is behaving erratically, the gyroscopes may
need to be recalibrated . Do not attempt to do this while flying . Safely land the drone
before attempting this procedure .
Place the drone in a horizontal location . Pull both control sticks to the bottom left (45°) at
the same time for 2 seconds, then release both sticks . The drone will flash to start gyro
calibration . When the drone flashes for 2 seconds and then stops flashing, the calibration
is complete and the craft is ready to fly .
HEADLESS MODE
You can set the forward direction of your drone relative to your controller's position . The
end of the drone facing away from you will be "forward", regardless of the position of the
front and back of the drone .
To enter Headless Mode, place the drone in front of the Controller .
After take off, long-press the Headless Mode button for 2 seconds .
The drone will beep, indicating that it is now in headless mode .
To exit Headless Mode, press the Headless Mode button for 2 seconds .
NOTE: When using Headless Mode, the drone must be in front of the
Controller .
KEY RETURN
To bring the drone directly back to the Controller, press the Light
Control/Key Return button for 2 seconds . A beep will sound, the
drone's lights will flash, and the drone will return to the Controller .
To cancel the return, press the Light Control/Key Return button for 2
seconds .
NOTE: The Controller will not control the drone during the return .
14
STUNT PLAY
When the drone is in land and sea mode and you are operating at high speed (with the
Speed 80% or 100% button activated), if you press the Speed Control Stick (the left
stick) up the drone will fly up in a dramatic display .
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
When starting the drone, the
Unable to sync to the
indicator lights flash but there
Controller .
is no response to Controller
controls .
Pressing the drone's start
The battery may be depleted .
button does not start the drone .
The motor does not respond to
The battery may be depleted .
the speed stick, the Controller
LED flashes .
The main rotor continues to
The Speed Trim accidentally
spin after landing .
increased during flight .
The main rotor spins but the
The main blades have been
drone is unable to take off .
damaged or the battery is
depleted .
The drone has a strong
The main blades have been
vibration .
damaged .
The tail is not trimmed after
The tail drive motor or tail
adjustment, or there is
rotors have been damaged .
inconsistent speed during left/
right spin .
SOLUTION
See Page 10 for sync
instructions .
Recharge the battery .
Recharge the battery .
Confirm that the Speed Trim is
in or slightly below the center .
Replace the blades or charge
the battery .
Replace the blades .
Replace the motor or replace
the main wing .
15
Advertisement
Table of Contents
