Selecting Air Or Land/Water Mode; Trimming The Drone; Ending Flight - Brookstone Flight Force 324457 User Manual

SELECTING AIR OR LAND/WATER MODE

You can operate the drone in the air, on land, or in the water . Press either Mode Button to
select your mode . In land and water mode, the rear propellers tilt forward .
In air mode:
• Press the Speed Control Stick (the left stick) up and down to control the height of
your flight; press left and right to turn left and right .
• Press the Direction Control Stick (the right stick) up to fly forward, down to fly
backward, left and right to fly left or right .
In land/water mode:
• Press the Speed Control Stick (the left stick) up and down to control the speed of
your drone; press left and right to turn left and right .
• Press the Direction Control Stick (the right stick) to move forward; press left and
right to move left and right . You cannot move backward in land/water mode .
When using the drone in water, note the following .
• Before placing or landing in water, check that the waterproof switch cover is in place .
After removing from water, open the switch cover and check that the switch is dry . If
necessary, gently dry the switch .
• If the drone's head tilts forward, the blades will beat the water and forward
resistance increases . Correct the tilt .
• If the drone capsizes, push the left control stick to flip the drone over .
• Do not operate at high speed in water, which may cause the drone's head to tilt up,
risking a backflip . If the drone flips, it may fly out of the water .
• Press the right joystick backward to slow down .
12

TRIMMING THE DRONE

To ensure that your drone can fly straight and level, you must calibrate its movements so
it remains stable both in takeoff and in flight . This is referred to as trimming .
Slowly raise the Speed Control Stick . Just as the drone lifts off the ground, use the trim
buttons to make adjustments .
• If the nose leans right, press the Direction Trim to the left . If the
nose leans left, press the Direction Trim to the right .
• If the nose leans forward, press the Forward/Backward Trim
down . If the nose leans backward, press the Forward/Backward
Trim up .
• If the body leans right, press the Crab Trim to the left . If the body
leans left, press the Crab Trim to the right .

ENDING FLIGHT

To end your flight, bring the drone back to a safe position, then switch off the Controller
and drone . If you will not be flying again for several days, remove the batteries from the
Controller and store them in a cool, dry place until your next flight .
13