Radio Shack ET-687 Owner's Manual page 10

43-687.fm Page 10 Friday, August 13, 1999 11:12 AM
2. Insert the bracket's tabs into the
base's lower tab slots as shown,
then press down on the bracket's
clips and insert them into the clip
slots.
Lower Tab Slots
Tabs
Clip Slots
3. To connect the phone to a two-line
phone jack , plug one end of the sup-
plied two-line phone cord into the
jack on the back of the
TEL LINE 1/2
phone.
Note: If you connect the phone to a
two-line phone jack with a two-line
cord, do not connect a cord to the
jack or the phone might
TEL LINE 2
not operate properly.
To connect the phone to two one-
line phone jacks , plug one end of
the supplied two-line cord to the
jack, and plug another cord
LINE 1/2
(not supplied) into the
jack.
10
To connect the phone to a single
one-line phone jack , plug one end of
the supplied cord into the
1/2
4. Insert the supplied AC adapter's
barrel plug into the
5. Route the modular and adapter's
cords through the grooves on the
bracket as shown. If you are using
two phone cords, route the second
cord through one of the wide
grooves on the bracket.
TEL
TEL LINE 2
or jack.
TEL LINE 2
DC IN 9V
TEL LINE
jack.
Grooves