Digital Display - GREE ELECTRIC GWH07PA-K3NNA3B Service Manual

LOCK icon:
21
is displayed by pressing "+" and "-" buttons simultaneously.Press them again to clear the display.
SET TIME display:
22
After pressing TIMER button, ON or OFF will blink.This area will show the set time.

DIGITAL display:

23
This area will show the set temperature. In SAVE mode,"SE" will be displayed. During defrosting operation, "H1" will be displayed.
AIR icon:
24
is displayed when pressing the AIR button.Press this button again to clear the display.(Optional for some models.)
HEALTH icon:
25
is displayed when pressing the HEALTH button.Press this button
X-FAN icon:
26
is displayed when pressing the X-FAN button. Press this button again to clear the display.
TURBO icon:
27
is displayed when pressing theTURBO button.Press this button again to clear the display.
FAN SPEED display :
28
Press FAN button to select the desired fan speed setting(AUTO Low-Med-High).Your selection will be displayed in the LCD windows,
except the AUTO fan speed.
I FEEL icon:
29
is displayed when pressing the I FEEL button.Press this button again to clear the display.
8 Heatingicon:
30
is displayed when Pressing "TEMP" and "CLOCK" simulta-neously in Heat mode.
Remote Controller Description
1
ON/OFF :
Press this button to turn on the unit .Press this button again to turn off the unit.
▲
2
Press this button to increase set temperature. Holding it down above 2 seconds rapidly increases set temperature. In AUTO mode,
set temperature is not adjustable.
3
MODE :
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL,DRY, FAN,and HEAT
following:
AUTO COOL DRY
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on the LCD, and the unit will
automatically select the suitable operation mode in accordance with the room temperature to make indoor room comfortable.
4
SWING:
Press this button to set up &down swing angle, which circularly changes as below:
This remote controller is universal . If any command
indicates the guide louver swings as:
:
5
Press this button to decrease set temperature.Holding it down above 2 seconds rapidly decreases set temperature. In AUTO
mode, set temperature is not adjustable.
6 FAN :
This button is used for setting Fan Speed in the sequence that goes from AUTO,
Low speed
*
FAN HEAT
*Note:Only for models with heating function.
OFF
Auto
Medium speed
again to clear the display.
, or is sent out, the unit will carry out the command as
High speed
,
,
, to then back to Auto.
, as the
*