Handle; Wheels And Feet - Grizzly G9743 Owner's Manual

Handle

Components and Hardware Needed:
Handle ............................................................... 1
Hex Nut ⁄ "-18 ................................................. 4
5
16
Flat Washer ⁄ " ................................................. 8
5
16
Hex Bolt ⁄ "-18 x 1 ⁄ " ....................................... 4
5 1
16 2
To install the handle:
Position the handle onto the end of the cabinet
as shown and fasten it in place with the four
hex bolts, eight flat washers, and four hex nuts
(Figure 8).
Handle
Foot Locations
Figure 8. Handle installed.
-16-

Wheels and Feet

Qty
Components and Hardware Needed:
Wheels ............................................................... 2
Axle ................................................................... 1
Cotter Pins 3 x 25 .............................................. 2
Flat Washers
Hex Nut ⁄ "-12 ................................................... 2
1
2
Foot ................................................................... 2
To install the wheels and feet:
1. Insert the axle into the cabinet (Figure 9).
2.
Position a
each wheel and slide the wheel onto the axle
end.
3.
Install the cotter pin into the end of the axle to
hold the wheel on.
4.
Install the remaining wheel in the same man-
ner.
5. Thread on one
foot.
6. At the handle-end of the cabinet (Figure 8),
thread each foot into the cabinet and tighten
the hex nuts to lock the feet into place.
⁄ " ................................................ 4
5
8
Axle
Figure 9. Installing wheel.
⁄ " flat washer on each side of
5
8
⁄ "-12 hex nut onto each
1
2
Model G9743 (Mfg. since 12/07)
Qty