KTI-5 NETWORK BOX INSTRUCTION MANUAL MODULE RÉSEAU MODE D’EMPLOI UNIDAD DE RED MANUAL DE INSTRUCCIONES INTERFACCIA IP NETWORK MANUALE DI ISTRUzIONI NETzWERK INTERFACE BEDIENUNgSANLEITUNg NETWERK EENHEID gEBRUIKSAANWIjzINg NETWORK BOX KULLANIM KILAVUzU B5A‑0555‑00 (M)
This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved by the party responsible/jVC KENWOOD. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
Thank you We are grateful you chosen kEnWooD network box. Warning • Do not install the unit in explosive atmospheres (inflammable gas, dust particles, metallic powders, grain powders, etc.). PrECauTionS • This unit operates in 13.6 V negative ground systems only!. Check voltage of DC power supply before installing the unit. • Do not expose the unit to rain or moisture; to prevent fire or electric shock. • Do not open the unit under any circumstances; to avoid risk of electric shock. • Do not expose the unit to long periods of direct sunlight, nor place it close to heating appliances. • Do not place the unit in excessively dusty and/or humid areas, nor on unstable surfaces. • If you detect an abnormal odor or smoke coming from the unit, disconnect the power from the unit immediately. Contact your KENWOOD service center or dealer. information on Disposal of old Electrical and Electronic Equipment (applicable for...
Part number Quantity N SYNC Cable E30-7717-XX Cushion G1D-0077-XX Cushion G13-2339-XX Instruction Manual B5A-0555-XX inSTallaTion & ConnECTion note: Please consult your dealer for installing the KTI-5 and repeater. To External KTI-5 IP NETWORK DC Power supply ROUTER NXR-710/810 N S Y N C Supplied Can be used with either N SYNC Cable connector (Length: 1 m)
Attach the KTI-5 to the repeater Accessory Cabinet using the supplied cushion. 1. Attach 4 cushions on the 4 base corners of the KTI-5, and place it into the Accessory Cabinet. 2. Attach the cushion to the base of the KTI-5, and attach it to the Accessory Cabinet. Cushion Cushion Cushion oriEnTaTion rear Panel Indicator Indicators (LAN) ① ② ③ ④ ⑤ ① DC Power supply connector cable (length: 2 m) Connect to an external DC power supply. ② n SynC jack Connect to Repeater. ③ lan jack Connect to Ethernet. Use a shielded, Category 5e or higher standard LAN cable shorter than 3 meters. ④ micro uSB connector This connector is currently not used.
indicators indicator Color Meaning Green Lights while the power is ON. STATUS Green/ Red/ Yellow/ Blue/ Indicates status condition. Purple LAN : Right Green Lights when in 100Base-TX mode. (100Mbps) Lights when link effective. LAN : Left Green (Link) Blinks when carrier sense operation.
© 2015 JVC KENWOOD Corporation...