Advertisement
For example, if Timer1 ON is set to 12:00 for
Timer1 and Timer1 OFF is set to 15:00, then
the values of Timer2 ON and Time2 OFF can
be accessed in the range of 12:00-15:00. If
timing intervals cross each other, the timed-on
signal is sent in the case of Timer ON, and the
timed-off signal is sent in the case of Timer
OFF. After timer setting is completed, the
corresponding prompt is displayed on the
main interface.
◆
Setting the weekly schedule:
Select "WEEKLY SCHEDULE", and press
the "OK" button to enter the interface. The
interface display is as follows:
WEEKLY SCHEDULE
ACT
T. ON
ON
00:00 A
OFF
00:00 A
OK
At most two timing segments can be set each
day in the weekly schedule, and the ON and
OFF time needs to be set for each timing
segment (the set internal is 10 minutes).
Operation instructions:
Press the "▲" and "▼" buttons to select the day
to be set; when the cursor stays at "ACT", press
the "▲" and "▼" buttons to select the Timer1 or
Timer2 parameter value "OFF" (default value,
indicating that the timer of this segment is invalid),
and use the "▲" and "▼" buttons to adjust the
parameter value to "ON" (indicating that the timer
of this segment is valid).
Press the "◄" and "►" buttons to select the start
time and end time to be set; press the "▲" and
"▼" buttons to select Time1 or Time2, press the
"OK" button, and use the "▲" and "▼" buttons to
adjust the time. After setting, press "OK" to
confirm saving, or press "BACK" to cancel setting
and return to the upper layer page. If Time1 ON is
set the same as Time1 OFF, the setting is invalid.
After the ACT option for timing of this segment
jumps to "OFF" and setting is completed, press
"OK" to confirm saving, or press "BACK" to cancel
setting and return to the upper layer page.
T. OFF
Note: Some days or all the 7 days can be set for
the weekly schedule; after the weekly schedule is
00:00 A
set, the corresponding prompt is displayed on the
main interface.
00:00 A
9
Advertisement
