Page 2
THANK YOU FOR YOUR PURCHASE OF TUMO-INT WIND TURBINE GENERATOR KIT. BEFORE ASSEMBLY, PLEASE CAREFULLY READ THE OWNER'S MANUAL SAFETY OUTSTANDING PERFORMANCE. ENJOY CONVENIENCE WHICH TUMO-INT WIND TURBINE GENERATOR KIT BRINGS YOU! THE OWNER'S MANUAL ISSUED ON JULY 2011. PLEASE UNDERSTAND IN CASE...
Page 3
Please make sure you’ve carefully read the manual before any assembly, installation or operation of your Tumo-Int wind turbine, it will help you to better improve Tumo-Int wind turbine using experience. If failure of following this Tumo-Int wind turbine manual’s instructions and requirements, Tumo Int Corp.
Page 4
Safety instructions before installation: 2.2.1 Install Tumo-Int wind turbine on sunny day. 2.2.2 Do not install Tumo-Int wind turbine during dusty day with more than 10 m/s wind speed. 2.2.3 Wear wet gloves or clothes are prohibited.
Page 5
2.4.4 Any cables or wires of the system, which might be damaged due to outdoor exposure, should be coated with conduit for protection. 3. Precautions: Operators must clearly know safety measurement. Safety relies on our joint efforts. 3.1 All operations must: a.
The blades are of exceptional consistency and aerodynamic outline with a mass distribution that ensures the rotor operates with minimum noise and minimal vibration. Tumo-Int wind turbine has very low start-up/cut-in wind speed and a high coefficient of productivity, which is specially designed to prevent the blades from feathering post stall.
Fig.1 Three ---- Application Range At present, Tumo-Int wind turbine has widely applied in: 3.1 Lighting System: city street lights, road lights, landscape lighting; 3.2 Highway Monitoring; 3.3 Telecommunication;...
Page 9
4.2 Selection of Tumo-Int Wind Turbine Tumo-Int wind turbine is applicable to various-climate regions. Please fully consider the surrounding environment resources to bring the best performance while selection of Tumo-Int wind turbine. 4.2.1 Wind Speed: low wind speed wind turbine could effectively utilize wind energy from low wind speed region, it's recommended to use low wind speed model in no hurricane areas with annual wind speed of less than 3.5m/s.
Five --- Wind Turbine Assembly Most of Tumo-Int wind turbine assembly has been finished in the factory; installation on site is simpler, mainly including mounting blades on the hub, mounting wind turbine on the tower, suspension setting on site and system wiring.
Page 11
⑴ The blades (total five). ⑵ The hub of five blades. ⑶ One-to-one mounting blade on the hub ⑷ Completed pattern. according to the number of blade and hub and screw down the nuts. ⑸ The wind turbine. ⑹ Screwing out one terminal of cable cover and connect the cables three-phase wire with wind turbine three-phase wire.
⑿Assembly finished(lightning rod is onto the hub (strength equally). optional). Six --- System Configurations There are three common system configurations for Tumo-Int 3000W wind turbine: (A) Wind and solar Tumo-Int hybrid power system for home: (B) Wind turbine power system for home:...
Page 13
Off-grid controller is divided into direct charging controller, wind and solar hybrid controller. User can choose by the corresponding wind turbine. In general, Tumo-Int wind and solar hybrid controller can be used the same as charging controller, however, charging controller can not be used in wind and solar hybrid power system.
Page 14
For selection of wire size, the following factors should be taken into consideration: ① Measuring the distance from the batteries to your Tumo-Int wind turbine. Be sure to include height of the tower;...
③ Your system power distance. For selection of wire size, the following factors should be followed: ① Practical and affordable; ② Satisfying using condition; ③ The positive pole of battery is red line, negative pole is black line(or blue line); The following wiring sizes provide maximum annual energy losses of 5% or less for sites with a 5.4m/s average wind speed (assuming the standard Rayleigh distribution of wind speeds) which is sufficient for most sites.
The controller specification and detailed debug methods are subject to controller manual. Eight --- Maintenance Although your high reliability of Tumo-Int wind turbine has been designed to run for long periods without requiring any maintenance, reliability and performance will be enhanced if...
you periodically inspect your system. The following situations need regular maintenance: Every Every a Every Every After Maintenance item year five storm months years years Check the guy rope tightness of tower √ √ Check the working condition of the whole √...
Page 18
9.4 Wind Turbine Insensitive to Adjust Blades Direction Tumo-Int wind turbine mainly adopts tail yaw to adjust the blades direction, if it is not sensitive to adjust blades direction, which is because the turbine alternator shaft is damaged, the tower is out of vertical, in case of these situations, the shaft should be replaced and tower vertically must be adjusted.
9.10 On-grid inverter faults and trouble shooting refers to inverter fault codes and solutions. Ten --- Packing, Transportation and Storage 10.1 Tumo-Int wind turbine components are packaged separately in accordance with national standard packaging requirements. 10.2 Tumo-Int wind turbine meets transportation requirements of all components.
Page 20
10.4 The packaging design of Tumo-Int wind turbine meets the following criteria: GB/T 4857.3 Transport Packages Stacking Test Methods Using a Static Load GB/T 4857.5 Transport Packages Drop Test Methods GB/T 1974-88 General Specification for Transport Packages of General Cargo...
Page 21
WIND SPEED、WIND TURBINE AND NATURAL CONDITION COMPARATION Tropical Wind Wind Wave cyclone speed( equivalent to pressure Classificat height (m) classific Appearance on Land Appearance on Water 10m high of ground) (10N/m²) ation High km/h Calm, smoke rises Calm Sea surface smooth and mirror-like. 0.0~0.2 <1 0-0.0025...
Need help?
Do you have a question about the 3000W 5 Blades Wind Turbine and is the answer not in the manual?
Questions and answers