Radio Shack 43-3820 Owner's Manual page 12

± ±
"016'"
The phone exits the setting
mode if you:
• wait more than 2
seconds between key
presses
• receive an incoming call
• press PLAY/STOP
• press TALK/FLASH on
the handset
Start again at Step 1.
12
If the battery power is too low, the dial mode might
reset to tone. If you are on a pulse line and cannot
make a call, try re-setting the dialing mode to pulse.
5
'66+0)
6 18
10'
You can select one of the handsets' four different
ringer tone/volume settings or turn the ringers off.
You can also select a different tone/volume for each
handset.
At any time, except during a call, repeatedly press
8 8 8 8 or 9 to select the desired ringer setting. Each
time you press a button, the phone rings at the
selected setting and
Bem Bem H_d]ýJof[ý8ý>_]^ H_d]ýJof[ý8ý>_]^
Bem Bem H_d]ýJof[ý8ý>_]^ H_d]ýJof[ý8ý>_]^
,
appears.
6
740+0)
1 11
0
You can set the base's ringer to high or low, or turn
it off.
1. Press
sounds, and the current setting appears. When
the ringer is set to
"Off."±
"
2. Repeatedly press
current setting. The system rings at each
setting change and
3. Press
mode.
Even when you turn off the base's ringer, you can
still make or receive calls using this phone.
Telephones on the same line and the handset (if its
ringer is not turned off) still ring when there is an
incoming call.
" "*
6*' #0&5'6
1.7/'
H_d]ýJof[ý7 H_d]ýJof[ý7 >_]^
H_d]ýJof[ý7 H_d]ýJof[ý7
H_d]ýJof[ý8ýBem H_d]ýJof[ý8ýBem
H_d]ýJof[ý8ýBem H_d]ýJof[ý8ýBem
,
" "$
6*' #5'
"
((
. The phone's currently set ring
SET/RING
E< E< E< E<
, the phone announces
SET/RING
>_ >_ >_ >_ Be Be Be Be
,
to store and exit the setting
PLAY/STOP
N "4
5 +0)'4
>_]^ H_d]ýJof[ý7ý H_d]ýJof[ý7ý
>_]^ >_]^ H_d]ýJof[ý7ý H_d]ýJof[ý7ý
,
ý ý ý ý H_d][hýE\\ý H_d][hýE\\ý
H_d][hýE\\ý H_d][hýE\\ý
, or
N "4 "
5 +0)'4
to change the
E\ E\ E\ E\
, or appears.
"