Dismantling Of The Amp Board - Philips HTS3565/98 Service Manual

DISASSEMBLY INSTRUCTIONS
Dismantling of the Front Panel Assemble
1) Open the DVD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tray
Cover.
Note: If this is not possible, the DVD Tray has to be open manually.
Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in gure 2 . Place the set on its
side, insert the mini screw driver till the marking and slide it towards the right as shown in gure 1 until the Tray moves out of the
Front Panel.
2) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back
in.
24mm
3 - 1
Figure 1
Figure 2
Figure 3
3) Loosen 7 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear.
- 1 screw "A" each on the left & right side as shown in gure 4
- 5 screws "B" at the back panel as shown in gure 5
4) Loosen 1 screw "C" each left & right side on the front panel after move the top panel as shown in gure 6.
5)Loosen 6 screws "D" at bracket of front panel as shown in gure 7
A
Figure 4

Dismantling of the AMP Board

1) Loosen 4 screws to remove the AMP Board.
- 2 screws " E " on the top of AMP board as shown in
- 2 screws " F " at the back panel as shown in gure 9
E
Figure 8
3 - 1
C
Figure 6
B
Figure 5
D
Figure 7
gure 8
F
Figure 9