Download Print this page

DIGITAL YACHT iKConnect Installation And Instruction Manual

Hide thumbs Also See for iKConnect:

Advertisement

Quick Links

iKConnect
Wireless
Router

Advertisement

loading
Need help?

Need help?

Do you have a question about the iKConnect and is the answer not in the manual?

Questions and answers

Summary of Contents for DIGITAL YACHT iKConnect

  • Page 1 Wireless Router...
  • Page 2: Before You Start

    An iKommunicate Gateway  A standard RJ45 Network cable To use the iKConnect to share a long range Wi-Fi internet connection on board the boat, then you will need a;  Digital Yacht WL70 Long Range Wi-Fi Adaptor 3. Installation Before starting installation select a suitable location for the iKConnect Router.
  • Page 3 IMPORTANT – if connecting the iKConnect to a Digital Yacht WL70 Long Range Wi-Fi Adaptor, remember that the WL70 only has a 5m USB cable, which should not be extended, so make sure that the iKConnect is sited within 5m of where the WL70 is mounted.
  • Page 4 As network traffic is transmitted/received on any of the network ports, the relevant LED will flash.  On the following page, is a typical network diagram showing how the iKConnect can be used as the wireless router on the boat.
  • Page 5: Network Configuration

    4. Network Configuration Digital Yacht have pre-configured the iKConnect so that in most situations it will work straight out of the box with no additional configuration required. The iKConnect default settings are as follows; IP Address 192.168.1.1 Subnet Mask 255.255.255.0 DHCP Range 192.168.1.100 to 192.168.1.250...
  • Page 6 WL70 plugged in to the iKConnect USB port. The internal iKConnect wireless network is always listed first and this is the one that you want to change, so click the “Edit” button for the iKConnect network. You should now be taken to the iKConnect network setting page shown in Fig 4.
  • Page 7 If you are using the iKConnect with the Digital Yacht WL70 long range Wi-Fi adaptor, then whenever you arrive at a new marina, you will need to login to the iKConnect to make the WL70 connect to the marina hotspot. This can be done from any Smart Phone, Tablet or Computer that is connected to the iKConnect, by opening the browser on the device and typing the iKConnect IP address (192.168.1.1) in to the browser’s address bar.
  • Page 8 6. Using iKConnect with other Network Devices iKConnect has two network connectors for connecting it to other wired network devices as shown in Fig 12. By default the left hand connector is setup to be a WAN connection for connecting to the Internet via a long range Wi-Fi adaptor like Digital Yacht’s WL510 or a 3...
  • Page 9 Should this happen, it is an easy process to reset iKConnect to its factory defaults. Apply power to iKConnect and allow 30 seconds for it to fully boot up.