Advertisement
MAINTAINING THE ICE BUCKET
• To clean the ice bin/bucket, wash with a mild
detergent, rinse well, and dry thoroughly.
Do not use harsh or abrasive cleaners or
solvents.
• Ice is made in cubes. When you select
"Crushed", the ice maker grinds the ice cubes
into crushed ice.
• When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
• The ice cubes generated by the rapid ice
making process will look white, which indicates
they are generated normally.
• If ice doesn't come out, pull out the ice bucket
and press the Test button located on the right
side of ice maker. See the illustration under
Making Ice below.
• Do not press the Test button continuously if
the tray is filled with ice or water. Water may
overflow or ice may jam the bucket.
MAKING ICE
• To fill the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and cool
down for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to
cool properly.
2. Dispense 4 to 6 ice cubes into a glass.
3. After another 8, and then 16 hours, dispense a
full glass of ice.
• To test the ice maker, press the Test button
on the ice maker. You will hear the refrigerator
chime (ding-dong). When the chime sounds,
release the Test button.
• The chime sounds automatically again to let
you know the ice maker is working well.
DA68-03013B (EN)-06-
.indd 38
• If you want to remove ice cubes without
using the ice bucket, turn the ice maker
CAUTION
off and remove the front cover from the
ice maker. Then, remove the ice cubes.
Note that with the cover removed, the ice
cubes in the ice maker can spill out.
• Do not put food in the ice bucket. If you
store food in the ice bucket, the food can
CAUTION
strike the ice maker when you open or
close the door, causing damage to the
ice maker.
• Note that the ice cubes in the ice bucket
may spill out over the drawer when you
CAUTION
remove the ice bucket from the drawer.
If this occurs, be sure to pick up any ice
cubes that spill.
• If a power failure occurs, ice cubes
may melt then freeze together when
CAUTION
the power comes back on, causing the
dispenser to stop working.
To prevent this problem, after a power failure, pull out
the ice bucket and discard the residual ice or water.
• If you use all the ice at once, you must
repeat ice making Steps 2 and 3.
However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production.
English - 38
check the
water level
Test button
2015. 8. 26.
10:00
Advertisement
