Table of Contents
Advertisement
3-4-2. Mounting in a 1-hole design
Unscrew the electrode mounting set and fix
the cable and electrode as shown in fig. 3-8.
3-4-3. Mounting in a 3- and 4-hole
design
Unscrew the nut from the top end of the
fitting or subassembly. Fix the electrodes
and cables as shown in fig. 3-9.
Note: In the holes for placing the electrodes
are blanking plugs (stoppers). These
plugs can be placed in unused holes
after pushing the two O-rings over the
bottom end.
ATTENTION
To prevent fouling of the contact new
Yokogawa electrodes are delivered with a
cap. It is recommended to remove the cap
just before fixing the cable.
ENSURE THAT THERE IS NO MOISTURE
OR DUST IN THE PLUG
4. ACCESSORIES
4-1. General
For mounting the non-DIN sized sensors in
the fittings and subassemblies Yokogawa
added a range of accessories to the program
of fittings which can be indespensable tools
for optional measuring tools (the
specifications of the accessories are on
seperate sheets, see GS 12B6J1-E-E).
See the chapters below for mounting the
accessories.
4-2. Mounting kit for BELLOMATIC
electrodes (Model FP20-S13)
Using this mounting kit a BELLOMATIC
electrode of Yokogawa can be fixed in a
fitting or subassembly (see fig. 4-1).
This mounting kit can also be used for fixing
combined electrodes.
Figure 3-8
ELECTRODE
"O"-RINGS
(11 X 3)
K1500BZ
Figure 4-1
11
Figure 3-9
RING (K1500HC)
RING (K1500HC)
IM 12B6K1-E-E
MOUN
Advertisement
Table of Contents
