Button Function Explanation; Setup - La Crosse Technology 308-1417BL Manual

Button Function Explanation

For better programming instructions, please note these terms for
button use:
• Press: Press and release the designated button.
• Hold: Hold the button for 3 seconds then release the button.

Setup

1. Install 2-AA batteries into the TX141TH-Bv2 sensor.
The red LED light will blink when transmitting.
2. Insert the 5.0 volt power cable into the wall outlet, then into the
station. Optional: Insert 3-AA batteries into the back of the station.
4. Keep sensor and weather station within 5 feet for at least 15
minutes after installing batteries. This allows the sensor and station
to sync properly and ensures a strong connection.
5. After 15 minutes, place sensor in desired location (position
sensor page
6. Program the station in the settings menu.
LED
TX
button
Note: Press the TX button inside the battery cover of the sensor to
force a signal transmission.
308-1417BL
11).
Power
Cord
www.lacrossetechnology.com/support
LIGHT
A A
A A
A A
Page | 2