1.11 Storage Conditions; 1.12 Installation Safety Information; 1.13 Electrical Installation Safety Information - ABB EBN853 Operating Instructions Manual

Safety
Pos: 4.23 /Überschriften/1.1/1-spaltig/J - L/Lagerbedingungen @ 8\mod_1176907016921_3101.doc @ 84229

1.11 Storage conditions

Pos: 4.24 /Sicherheit/Aktorik/Leistungselektroniken/EBN853, EBN861/Lagerbedingungen @ 13\mod_1191936604390_3101.doc @ 129230
The units may be stored under moist and aggressive condition for a short time. The equipment
is protected against external corrosive influences. However, direct exposure to rain, snow, etc.,
must be avoided.
For electronics modules delivered for use in anti-condensation areas, the electrical connection
chamber is protected by a desiccant.
The desiccant guarantees sufficient protection for approximately 150 days. It can be
regenerated at a temperature of 90 °C (114 °F) within 4 h.
Important
Remove the desiccant prior to commissioning the actuator or the electronic unit.
If you intend to store or transport the device for a longer time, we recommend that you wrap it in
plastic foil and add desiccant. Regularly check whether the desiccant is still active.
Pos: 4.25 /Überschriften/1.1/1-spaltig/S - U/Sicherheitshinweise zur Montage @ 0\mod_1140166528109_3101.doc @ 3208

1.12 Installation safety information

Pos: 4.26 /Sicherheit/Aktorik/Leistungselektroniken/Allgemein/Sicherheitshinweise zur Montage @ 13\mod_1191936460078_3101.doc @ 129206
• Only qualified specialists who have been trained for these tasks are authorized to mount and
adjust the control actuator, and to make the electrical connection.
• When working on the actuator itself or the electronics always observe the locally valid
accident prevention regulations and the regulations concerning the construction of technical
installations.
• Switch off the supply voltage and protect against unintentional startup.
Pos: 4.27 /Überschriften/1.1/1-spaltig/S - U/Sicherheitshinweise zur elektrischen Installation @ 0\mod_1140166567843_3101.doc @ 3207

1.13 Electrical installation safety information

Pos: 4.28 /Sicherheit/Temperatur/Allgemein/Sicherheitshinweise zur elektrischen Installation (Temperatur) @ 13\mod_1191930430247_3101.doc @ 128893
The electrical connection may only be performed by authorized specialist personnel according
to the electrical plans.
Comply with electrical connection information in the manual. Otherwise, the electrical protection
class can be affected.
The secure separation of contact-dangerous electrical circuits is only guaranteed when the
connected devices fulfill the requirements of the DIN EN 61140 (VDE 0140 Part 1) (basic
requirements for secure separation).
For secure separation, run the supply lines separated from contact-dangerous electrical circuits
or additionally insulate them.
Pos: 4.29 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
10 EBN853, EBN861 (Contrac) 42/68-830-EN