Advertisement
Quick Links
Advertisement
Related Manuals for Sparklan WUBR-170GN
Summary of Contents for Sparklan WUBR-170GN
- Page 1 WUBR-170GN Wireless-GN USB Module User’s Manual Version 1.0...
- Page 2 Contents 1. Package Contents......................3 2. WLAN Adapter Quick installation Guide................4 3. Network Card Installation....................4 4. Connect to Wireless Access Point .................. 7...
- Page 3 Copyright statement No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording, or otherwise without the prior writing of the publisher. September 2010...
-
Page 4: Package Contents
1. Package Contents Before you starting to use this wireless usb module, please check if there’s anything missing in the package, and contact your dealer of purchase to claim for missing items: Package Contents Please make sure you have the following in the box: ♦... -
Page 5: Wlan Adapter Quick Installation Guide
2. WLAN Adapter Quick installation Guide Please follow the following instructions to use Ralink configuration utility to connect to wireless access point. 3. Network Card Installation 1. Insert the USB wireless module into an empty USB 2.0 port of your computer when computer is switched on. - Page 6 “ Autorun.exe ”. 5. Click the “Driver” for beginning the installation. 6. Click “Next” and then follow the instructions on the screen to continue the installation. 7. You can choose the configuration tool used to configure the wireless network card here. It’s recommended to select ‘Ralink Configuration Tool’, which provides fully access to all function of this wireless network card.
- Page 7 8. When you see this message, please click ‘Finish’ to complete the driver installation process.
-
Page 8: Connect To Wireless Access Point
4. Connect to Wireless Access Point 1. After installation is complete, wireless configuration utility will be shown as an icon at the lower-right corner of your windows desktop. Please click the icon by right mouse key, and select ‘Launch Config Utilities’. 2. - Page 9 3. If the wireless access point uses encryption, you have to input WEP passphrase or WPA preshared key. Please ask the owner of the wireless access point you want to connect, and input the correct passphrase / preshared key here, then click ‘OK’. If the value you inputted here is wrong, you will not be able to connect to wireless access point.
- Page 10 4. If the wireless access point is successfully connected, you’ll see a ‘‘Status’ (SSID and MAC address of the wireless access point or wireless device you connected to) message displayed at the lower-left corner of wireless configuration utility window. Click ‘X’ to exit.
-
Page 12: Federal Communication Commission Interference Statement
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. - Page 13 size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the WUBR-170GN and is the answer not in the manual?
Questions and answers