Display - Klipsch CS-700 Owner's Manual

STEP 3A: Set-Top Box Connection
Use this connection if your TV has a cable box, satellite receiver or HD receiver set-top box connected to it.
See next page (3B) if no set-top box is used.
1.
Disconnect the cable on your cable, satellite or HD set-top box that is
connected to your TV (you need to connect 1 video and 1 audio).
2.
Connect the VIDEO—look at the options available on the set-top box
and choose 2A or 2B.
A. To maintain best picture quality—if the back of the set-top box
has any COMPONENT VIDEO (Y, P
corresponding cable(s) into the jack(s) on the set-top box and to
the Klipsch CS700'
jacks (Y to Y; P to P
B
also connect the corresponding output from the Klipsch controller's
"VIDEO OUTPUT" section to your TV to ensure that you get a picture.
These cables have not been included with the Klipsch system.
When using the HDMI connection you must turn Progressive Scan
( ) "On". If the HDMI connection are used and
is "Off", you will not see a picture.
B. If the set-top box has a VIDEO (yellow)
the supplied yellow video cable into that jack and to the Klipsch
system's SAT/CABLE/HD INPUT COMPOSITE
2A
, P ) OUTPUT jacks, plug
B R
SAT/CBL/HD INPUT COMPONENT
S
, P to P ). If you use 2A, you must
B R R
OUTPUT jack for video, plug
(yellow) jack.
2B
3A
3B
3.
Connect the AUDIO—look at the options available on the set-top box
and choose 3A, 3B, 3C.
A.
Connect the supplied audio cables to the AUDIO LEFT (white) and
AUDIO R
Klipsch system's
(red) jacks.
B.
If the set-top box has Digital AUDIO (COAXIAL), connect appropri-
ate cable to the set-top box AUDIO COAXIAL jack and to the
SAT/CABLE/HD INPUT COAXIAL
C.
If the set-top box has Digital AUDIO (OPTICAL), connect appropriate
cable (not supplied) to the Klipsch System's
OPTICAL jack. You will first need to remove the plastic dust plug.
Note: If you connect a high definition Y, P
connect the corresponding Y, P
HDMI, you must also connect the corresponding output from the Klipsch
controller's "VIDEO OUTPUT" section to your TV to ensure that you get a
picture. These cables have not been included with the Klipsch system.
Please see appendix I (page 28) for the basics on how input
and output jacks work with your Klipsch system.
3C
(red) jacks on the back of the set-top box and to the
SAT/CABLE/HD INPUT LEFT
jack.
SAT/CABLE/HD INPUT
, P INPUT, you must also
B R
, P OUTPUT to your TV. If you connect
B R
Input and Output Jacks
(white) and RIGHT