Download Print this page

T2 MD-4 Owner's Manual

Quad channel rack mount modulator

Advertisement

Quick Links

QUAD CHANNEL
RACK MOUNT MODULATOR
OWNER'S MANUAL
MD-4

Advertisement

loading

Summary of Contents for T2 MD-4

  • Page 1 QUAD CHANNEL RACK MOUNT MODULATOR OWNER’S MANUAL MD-4...
  • Page 2: System Setup

    Introduction:: System Set-up:: Thank you for purchasing this T2 modulator. T2 is the The diagram below shows how the MD-4 might fit into a brainchild of some of the most experienced professionals typical RF system. See fig 1. in the custom installation and home entertainment indus- tries.
  • Page 3 Mounting:: Features:: Your MD-4 was designed to be housed in a standard 19” Your MD-4 is a dual sideband modulator. When selecting a rack. Mounting screws have been included with your channel for modulation, ensure that that channel, along MD-4, which should be used to affix the front panel to with the following channel, is empty.
  • Page 4 MODB, MODC, and MODD. These are the four Fig. 4 modulation inputs. • Select the proper offset mode. Your MD-4 is equipped with video present LEDs that will • Select the desired channel using the buttons illuminate upon detection of a source signal. See fig. 5a.
  • Page 5: Specifications

    Specifications:: Troubleshooting:: Input:: No Picture:: S-Video: 0.4V to 2.7V Peak to Peak Ensure that the video source is on and generating a signal. Adjustable @ 75Ω Ensure that the TV and the modulator are tuned to the Audio: 1Vrms Adjustable @ 47KΩ same channel.
  • Page 6: Fcc Conformity

    AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE authorization (RMA) number and return the defective product together with a copy of the sales receipt or other satisfactory proof of purchase to T2 Signal RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDE- Management, 63 Mall Drive, Commack, NY 11725, Attention: Customer SIRED OPERATION.
  • Page 7 For more information, visit www.t2signal.com. For technical support, call 1.800.827.5540. 85P004A TERK and T2 are registered trademarks. The T2 logo is a trademark of TERK Technologies Corp.