Introduction:: System Set-up:: Thank you for purchasing this T2 modulator. T2 is the The diagram below shows how the MD-EM1 would fit into brainchild of some of the most experienced professionals a typical RF system. See fig 1. in the custom installation and home entertainment industries.
Page 3
Video Present Relay:: modulating, be sure to leave one channel open after the Your MD-EM1 comes equipped with a video present relay. channel that you are modulating to. For example, if you This can be connected directly to an a/v control system.
Page 4
Programming:: Video Present LED:: To program a channel into your MD-EM1:: Your MD-EM1 is equipped with a video present LED that • Ensure that the channel you wish to modulate onto, will illuminate upon detection of a source signal. along with the channel directly after that, is open.
Troubleshooting:: Mounting & Using the T2 Locking System:: No Picture:: Your modulator comes with the proprietary T2 locking Ensure that the video source is on and generating a signal. system attached, and is designed to be mounted in most Ensure that the TV and the modulator are tuned to the UL listed structured cable enclosures.
Specifications:: FCC Conformity:: DECLARATION OF CONFORMITY Inputs:: THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. Video: 0.8V to 2.7V Peak to Peak OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: Adjustable @ 75ohm (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, Audio: 1V Peak to Peak for AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE...
T2 Signal Management (T2) warrants this product to be free from defects in materials and workmanship for a period of three (3) years from the date of purchase or T2 will repair, or at its option, replace the defective product (with a new or factory reconditioned product, as T2 may determine).