Table of Contents
Advertisement
• In case of inactivity, disconnect after (minutes): The default is 10 minutes. Set
Wireless Setup
The following settings are the most important for the local Wireless LAN:
• SSID: The Service Set Identifier: enter a name for your local wireless network
• SSID broadcast: If you set the 'Enabled' checkbox to broadcast then other
Z08.209_UG_GSIII_V4.indd 45
• Connect Manually: connect to the Internet by clicking Connect on
the Connection Status page in the Graphical User Interface or press
the Connect button on GlobeSurfer
• Automatically connect upon traffic: GlobeSurfer
connect when you attempt to send data via the Internet.
it to zero (0) if you want the UMTS to stay connected. The maximum is 1440
minutes (24 hours).
Note: Incoming traffic is treated as inactivity.
(WLAN) (maximum 32 characters).
devices can detect and connect to your WLAN. You can install the WLAN with
this feature enabled and then disable it once you have set up GlobeSurfer
and its associated wireless clients.
Tip: You can clear this checkbox later to disable broadcasting and hide the
name of your network; this provides minimal security, as other devices have to
know the SSID to connect.
III.
®
III will automatically
®
45
III
®
14-08-2008 13:56:42
Advertisement
Table of Contents
