NAiS EBL512 Operating Instructions Manual page 5

Matsushita Electric Works Fire & Security Technology AB
MEW00442 Rev: -
17.2 Control Units in a TLON network ____________________ 48
17.2.1 TLON network programming (configuration) ______ 49
18 Programming (SSD download) _______________ 50
18.1 Single Control Unit ________________________________ 50
18.2 Control Units in a TLON network ____________________ 50
18.3 User definable text messages download ________________ 51
18.3.1 Download in Control unit ______________________ 51
18.3.2 Download in Display unit ______________________ 51
19 New system program (SW) version download ___ 52
19.1 Control Units in a TLON network ____________________ 52
20 EBL512 settings download___________________ 53
20.1 Control Units in a TLON network ____________________ 54
21 Reset / Restart _____________________________ 55
22 Access ____________________________________ 57
23 Perform monthly test (H1)___________________ 58
24 Disable or re-enable (H2) ____________________ 60
24.1 Disable zone (H2/B1) ______________________________ 61
24.2 Disable zone / address (H2/B2)_______________________ 62
24.3 Disable control output (H2/B3)_______________________ 63
24.4 Re-enable zone (H2/B4) ____________________________ 64
24.5 Re-enable zone / address (H2/B5)_____________________ 65
24.6 Re-enable control output (H2/B6)_____________________ 66
24.7 Re-enable non-reset zone / address (H2/B7)_____________ 67
24.8 Control on / Control off (H2/B8) _____________________ 68
24.9 Alarm device on / Alarm device off (H2/B9) ____________ 69
25 Set calendar and clock (H3) __________________ 70
26 Present system status on display and printer (H4) 71
26.1 Disablement (H4/U1) ______________________________ 71
26.2 Disablement by time channel (H4/U2) _________________ 72
26.3 Show open doors (H4/U3) __________________________ 73
26.4 Activated 2-zone/address dependent (H4/U4) ___________ 74
26.5 Show sensors week average values (H4/U5) ____________ 75
26.5.1 Reset of a sensor week average value _____________ 75
26.6 Show sensors momentary values (H4/U6) ______________ 76
26.7 Sensors activating SERVICE signal (H4/U7) ____________ 77
26.8 Show event log (H4/U8) ____________________________ 78
26.9 Show configuration (H4/U9)_________________________ 79
27 Programming (H5) _________________________ 80
27.1 Access code for programming (H5) ___________________ 81
27.2 Calibration of monitored outputs (H5/A1) ______________ 82
27.3 Sensitive fault detection mode (H5/A2) ________________ 83
27.4 Direction for communication on COM-loop (H5/A3) _____ 84
27.5 Show information about site specific data (H5/A4) _______ 85
Operating Instructions EBL512, V1.44.x
3