Related Manuals for Sensing Labs SenlabM PUL-LAB-13NS
Summary of Contents for Sensing Labs SenlabM PUL-LAB-13NS
- Page 1 SENSING LABS SAS Cap Oméga Rond-point Benjamin Franklin CS 39521 34960 - Montpellier Cedex 2 France www.sensing-labs.com support@sensing-labs.com SenlabM © PUL-LAB-xxNS User guide SENSING-LABS VERSION 02 – REV A / JULY 2017...
-
Page 2: General Overview
Sensing Labs SenlabM PUL-LAB-xxNS – User guide Thank you for your choosing our Senlab product! We hope you will find the instructions on this user manual clear and easy to follow. General overview The Senlab Metering (SenlabM) sensor is a smart LoRaWAN™... - Page 3 Sensing Labs SenlabM PUL-LAB-xxNS – User guide Provisioning of the device You have to be sure that your Senlab device has been well commissioned to be able to reach your LoRaWAN network. ✓ Contact if needed your distributor to get your Senlab configuration ✓...
-
Page 4: On-Site Installation
Sensing Labs SenlabM PUL-LAB-xxNS – User guide On-site installation ➢ POSITIONING : You have first to find the best position to your Senlab: ✓ Prefer vertical position (antenna part upwards) ✓ Avoid positioning the pulse cable pulled vertically under the device (prefer... -
Page 5: Activation Of The Device
Sensing Labs SenlabM PUL-LAB-xxNS – User guide Now the device is well physically installed and plugged, you need to activate it in order to start counting functionality as well as radio connection. ➢ Pairing to meter can be done with a default raw index before the activation step by using SLsetting tool. - Page 6 Sensing Labs SenlabM PUL-LAB-xxNS – User guide Application features (datalog mode) This chapter describes the SenlabM application features available in datalog mode (accessible via SLbase or SLcodec – refer respective User Guide for more details) Measure data Description Type Unit...
- Page 7 Sensing Labs SenlabM PUL-LAB-xxNS – User guide Standard mode (1 log per transmission) This chapter describes the SenlabM application standard frame formats for decoding device payload by yourself. Uplink message RESTART - FPort 4 (for device configured in standard mode) This frame is automatically sent after a successful network connection for informing the application layer of its activation.
-
Page 8: Electrical Safety
Sensing Labs SenlabM PUL-LAB-xxNS – User guide Security Electrical safety All circuits are SELV (Safety extra low voltage), including interface circuits which are only used for measurement (signals without power, these circuits are considered LPS). Battery replacement (Indoor version only) Replacement battery must by a Lithium 3,6V AA type with 50mA min of supported continuous current ... - Page 9 SENSING LABS SAS. © 2017 SENSING LABS SAS. All rights reserved. Sensing Labs logo, are registered trademarks of SENSING LABS SAS. All other brands and product names mentioned in this document are the property of their respective holders.
Need help?
Do you have a question about the SenlabM PUL-LAB-13NS and is the answer not in the manual?
Questions and answers