Advertisement
05. OPERATION INSTRUCTIONS
The moving head is for beam effect for on-site decoration purpose.
●
Don't turn on the fixture if it's been through severe temperature difference like after
●
transportation because it might damage the light due to the environment changes. So
make sure to operate the fixture until it is in normal temperature.This light should be
keep away from strong shaking during any transportation or movement.
●
Don't pull up the light by only the head, or it might cause damages to the mechanical
●
parts.
Don't expose the fixture in overheat, moisture or environment with too much dust when
●
installing it. And don't lay any power cables on the floor. Or it might cause electronic
shock to the people.
Make sure the installation place is in good safety condition before installing the fixture.
●
Make sure to put the safety chain and check whether the screws are screwed properly
●
when installing the fixture.
Make sure the lens are in good condition. It's recommended to replace the units if there
●
are any damages or severe scratch.
Make sure the fixture is operated by qualified personnel who knows the fixture before
●
using.
Keep the original packages if any second shipment is needed.
●
Don't try to change the fixtures without any instruction by the manufacturer or the
●
appointed repairing agencies.
It is not in warranty range if there are any malfunctions from not following the user
●
manual to operate or any illegal operation, like shock short circuit, electronic shock,
lamp broke, etc.
06. INSTALLATIONS
Cautions: For added protection mount the fixtures in areas outside walking paths, seating
areas, or in areas were the fixture might be reached by unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device's weight.
Fixture installation must always be secured with a secondary safety attachment, such as
an appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
from a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is
.05.
kept at least 0.5m (1.5 ft) away from any flammable materials (decoration etc.).
Always use and install the supplied safety cable as a safety measure to prevent accidental
damage and/or injury in the event the clamp fails.
Mounting points: Overhead mounting requires extensive experience, including amongst
others calculating working load limits, a fine knowledge of the installation material being
used, and periodic safety inspection of all installation material and the fixture. If you lack
these qualifications, do not attempt the installation yourself. Improper installation can
result in bodily injury.
Be sure to complete all rigging and installation procedures before connecting the main
power cord to the appropriate wall outlet.
Clamp Mounting: The moving head provides a unique mounting bracket assembly that
integrates the bottom of the base, and the safety cable rigging point in one unit (see the
illustration below). When mounting this fixture to truss be sure to secure an appropriately
rated clamp to the included omega bracket using a M10 screw fitted through the center
hole of the "Hanging Kit". As an added safety measure be sure to attached at least one
properly rated safety cable to the fixture using on of the safety cable rigging point
integrated in the base assembly .
Regardless of the rigging option you choose for your moving head, always be sure to
secure your fixture with a safety cable. The fixture provides a built-in rigging point for a
safety cable on the hanging bracket as illustrated above. Be sure to only use the
designated rigging point for the safety cable and never secure a safety cable to a carrying
handle.
②
① Omega Bracket
② Satety Clamp
③ Safety Cable
④ 1/4 Turn Quick-Lock Fasteners
①
④
1/4 Turn
.06.
③
1/4 Turn
Advertisement
