Advertisement
Advertisement
Table of Contents
Related Manuals for Alarm.Com ADC-NK-100T
Summary of Contents for Alarm.Com ADC-NK-100T
- Page 1 Rhein Tech Laboratories, Inc. Client: Alarm.com 360 Herndon Parkway Model: ADC-NK-100T Suite 1400 Standards: FCC 15.247/IC RSS-247 ID’s: YL6143NK100T/9111A-143NK100T Herndon, VA 20170 http://www.rheintech.com Report #: 2015014DTS Appendix K: Manual Please refer to the following pages. Page 48 of 70...
- Page 2 Alarm.com Hub Install Guide...
-
Page 3: Box Contents
Power Cable/ AC Adapter (Cellular Version) What You Need: Customer Account If you don’t already have a customer account with us, visit www.Alarm.com, and click on “Get Started” to find an authorized Alarm.com dealer near you. Works With: Thermostats Door Locks... -
Page 4: Installation
Step 1: Powering Up the Hub battery enables cordless pairing, so you can move With the Alarm.com Hub as your home’s command the Hub around your home as you pair it with center, you’ll gain remote control of your key •... - Page 5 Unpairing Z-Wave Devices (If all Z-Wave NOTE: Do not use lithium-ion batteries, which • First, put the Hub in Advanced Mode by pressing • Navigate to the Alarm.com Customer Website to devices were added successfully, skip to can damage the Image Sensor.
-
Page 6: Advanced Mode
Light will shine solid green for 10 seconds and the you can perform the following advanced actions. • Next, contact Alarm.com Customer Support to or panel. Hub will beep for one second. reinitialize the Hub. - Page 7 LIGHT PATTERN/BEEPS MEANING LIGHT COLOR LIGHT PATTERN/BEEPS MEANING Slow Blink Hub is in Unpairing Mode Solid Hub powered on and connected to Alarm.com Two beeps Fast blink No cellular signal strength. Hub not connected ORANGE Solid Device successfully removed to Alarm.com One blink Signal strength inadequate (1 out of 6 bars).
- Page 8 12 | Alarm.com Hub Install Guide Alarm.com Hub Install Guide | 13 Status Light Definitions (Continues) Advanced Mode Cellular Hub LIGHT COLOR LIGHT PATTERN/BEEPS MEANING LIGHT COLOR LIGHT PATTERN/BEEPS MEANING Solid No errors or status messages Slow blink Factory resetting initiated...
-
Page 9: Regulatory & Certifications
Changes or modifications not expressly approved by transmitter may only operate using an antenna of a Power Requirements 5V nominal Alarm.com can void the user’s authority to operate type and maximum (or lesser) gain approved for the the equipment. transmitter by Industry Canada. - Page 10 16 | Alarm.com Hub Install Guide Copyright © 2015 Alarm.com. All rights reserved. Alarm.com and the Alarm.com Logo are registered trademarks of Alarm.com.
Need help?
Do you have a question about the ADC-NK-100T and is the answer not in the manual?
Questions and answers